LED Lamp HPM-Retrofit, RL-HRL125 46W 840/E40, Radium

LED lamp to replace with lp. mercury vapor, non-dim, E40 base. Operation with BC (1:1 replacement) or at 230V. No UV or IR radiation.

Nominal power                                              46 W
Exchange traditional light source (W)      125 W
Lamp luminous flux in assigned field       6000 lm
Nominal luminous flux                                6000 lm
Colour temperature                                      4000 K
Average life                                                     50000 h
Average life                                                     50000 h
Lamp shape                                                    tubes, single base

General Data

43618304
RL-HRL125 840/E40
4008597183041
6
4008597483042
4.867
0.27
0.19
0.26
690 g

Electric Parameters

46.0 W
46.0 W
46 kWh
46.0-46.0 W
0.90
220-240 V
220 – 240 V
AC
210-210 mA
210 mA
23
36
No

Light Application Parameters

6000 lm
6000 lm
6000 lm lm
6000 lm lm
360 °
130 lm/W
4000 K
80-89
80-89
≤ 6 sdcm

Service Life

50000 h
50000 h
100000
0.90
1.0 %
5 years

Specification

old label, no EPREL registration, no EU data sheet
E
A++
80 mm
204 mm mm
204 mm
any
0.0 mg
Tube, single-ended
E40
White

Notes on Operation

IP65
any
-20…+80 °C
-20…+50 °C

Information especially for EPREL

old label, no EPREL registration, no EU data sheet
LED
No
875235

Notes

Base

Sockel-ZeichnungE40
IEC/EN 60061-1
sheet 7004-24-6

Spectrum

As daylight is a mixture of direct sunlight and light from the sky, the spectral distribution changes all the time due to the time of the day and the weather. The standard illuminant D65 corresponds to daylight with colour temperature of about 6500K.
The colour of coloured LEDs depends on the chemical elements within the light generating chip. The coloured light is generated directly and does not need filtering.
White LEDs are either RGB (red + green + blue chip in one LED = light colour white) or blue LED-chips with yellow/orange phosphor in the resin.
Visible region from 380 to 780 nm; height of graph corresponding with relative spectral emission (400mW/klm)per 10nm.

Spektrum 1

LED retrofit lamps 4000K

Spektrum 2

daylight(D 65)

Special features

PictoPictoPicto

General notes

When replacing mercury vapor lamps HRL with LED lamps, we recommend replacement at the respective light point with operation at mains voltage directly (disconnect ballast, for lamps with article no. 426…), newer generations may also be replaced 1:1 (ballast remains in luminaire,lamps with article no. 43…) An ambient temperature of the lamp of 60 ° C inside the luminaire must not be exceeded. Outdoor use is permitted (IP65).

The technical design data in accordance with DIN and IEC. The producer does not take any responsibility for damage to persons or property in case of unsuitable operation or handling of the product. Operating data and dimensions are valid within the usual tolerances. Related lamp types (different bases, mains voltages) may be available on request. Sale and delivery are effected in accordance with the Radium Terms of Delivery and Payment valid on the day of conclusion of contract. Packing units offer economical advantages to the purchase and logistic department. Please match your quantity volume accordingly. For orders of a minimum quantity (clefts) with a lamp model the amount lower than the volume of each packaging unit, we will invoice 10 % additional charge per lamp type. Technical changes and terms of delivery are reserved. Manipulation of any kind to packaging or product is not permissible as this will violate Radium brand rights. Furthermore, technical properties of the product can change to its disadvantage or even destruction. Therefore, Radium cannot be responsible for consequential damages.
® = Registered trademark
Subject to change without notice. Errors and omissions excepted.

Safety instructions

To ensure full light efficiency and product life, the permissible temperature ranges must be observed and dry environment ensured. When operated with existing control gear, their compatibility with the lamp must be checked.

Reviews

There are no reviews yet.

Be the first to review “LED Lamp HPM-Retrofit, RL-HRL125 46W 840/E40, Radium”

Your email address will not be published. Required fields are marked *